SECTION 7: RUDDER

Build Instruction Updates

• 11/06/20 07_10.pdf

Check for more recent updates here

Builder Videos

Plane Lady:

• 7-2,7-3,7-4
• 7-4,7-5,7-6
• Rudder skins
• Rudder mistake
• 7-6,7-7
• 7-8,7-9
• 7-10
• 7-10,7-11
• rolling leading edge
• 7-11, 7-12

Jason Ellis:

• 7, first pages
• 7-4, step1-3
• 7-4 step3 to 7-6 step3
• 7-6 to 7-9
• 7-9, step 2-8
• 7-10 to 7-12

Page 7-6 Step 11

"The holes" refers to the holes in the skin that are common to the rudder skeleton as defined in step 6. The bottom row of holes where the fairing attaches is not touched in this section, rather in section 12, page 12-3, steps 2 and 3.

Page 7-11 Step 2

There are many ways to roll the leading edge. One possible solution is to get a white powder coated steel closet rod at home depot, then go to the tools section and find a socket that fits snuggly into it. Drill two or three 1/8th holes through the rod and socket (with a tungsten carbide drill bit) and pop rivet the rod to the socket. Using a socket wrench with a universal joint, you can easily exert plenty of rolling force into the rod. Tape the skin to the rod using heavy duty duct tape.