SECTION 29: FUSE SIDE SKINS: Difference between revisions
Jump to navigation
Jump to search
m (→29-14) |
m (→29-15) |
||
Line 10: | Line 10: | ||
== 29-15 == | == 29-15 == | ||
* Questions on which holes to dimple? See [https://www.facebook.com/groups/vansrv10/posts/5839137336207317 this FB thread] | * Questions on which holes to dimple? See [https://www.facebook.com/groups/vansrv10/posts/5839137336207317 this FB thread] | ||
== 29-20 == | |||
* Don't rivet the forward cabin floor to the center tunnel walls if you are getting electronic injection (SDS or EFII), or you intend to install access covers to the side of the tunnel as the rivet holes will be needed. |
Revision as of 02:44, 22 August 2023
Build Instruction Updates
- 10/05/21 29_10.pdf
Check for more recent updates here
29-11
- See this FB Post on how to keep the skin and clamping block in place while bending.
29-14
- Step 5
When match drilling from the F-1001B angle into the WD-1002-L / WD-1002-R firewall steel brackets, be aware that it's easy to violate the edge distance in the steel bracket (2 x D, measured from the center of hole). Remedy is to temporarily install a bolt into the engine mount hole to pull the bracket into place and to use a clamp to move the steel bracket to increase edge distance.
See this build log
See also FB post 4/17/2022
See also FB post 3/27/2023
29-15
- Questions on which holes to dimple? See this FB thread
29-20
- Don't rivet the forward cabin floor to the center tunnel walls if you are getting electronic injection (SDS or EFII), or you intend to install access covers to the side of the tunnel as the rivet holes will be needed.